Flex-a-Lite 20 Electra-Fan - Manual

Electra-Fan 10 & 20
Installation Instructions
HEX WRENCH
DIAGRAM C
1. Fasten motor to bracket.
2. Attach the ring fan to the motor shaft: (See Diagram A)
To PUSH air through the radiator, place fan in front of radiator:
Attach fan so “Electra Fan”, printed on the fan hub, faces the electric
motor. Center fan hub in bracket, then tighten set screw on the flat
side of the motor shaft.
To PULL air through the radiator, place fan behind radiator:
Attach fan so “Electra Fan”, printed on the fan hub, faces away from
the electric motor. Center fan in bracket, then tighten set screw on
the flat side of the motor shaft.
IMPORTANT: FAN MUST ROTATE FREELY
Attaching electric fan to radiator:
(See Diagrams B & C)
1. Position the electric fan so that the temperature sensor bulb can reach
the top of the radiator inlet hose connection. Note: Electric fan should
cover the finned area. (DIAGRAM C)
2. Once position is determined, carefully pass a small Phillips screwdriver
through the bracket and radiator fins.
Caution: Be careful not to damage the tubes or core of the radiator.
3. Pass the metal bolts through the two curved bracket pads, then
through the radiator (opposite side of where screwdriver went through
the radiator), and then through the electric fan bracket. Fasten the (4)
washer and nuts provided to the metal bolts.
Caution: Do not over tighten. (DIAGRAM B)
IMPORTANT: FAN MUST ROTATE FREELY
rev. 07-08-05 99963
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E. Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing user, that all Flex-a-lite products to be free of defects in material and
workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the point of
purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite will
replace the fan free of charge, transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do not allow the exclusion or limitaion of
incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary from state to state.
The Flex-a-lite warranty is in compliance with the Magnuson-Moss Warranty Act of 1975.
MOTOR
BRACKET
FAN BLADE
SET
SCREW
CURVED
BRACKET
PLASTIC
BOLT
NUT
ELECTRIC
FAN
BRACKET
CURVED
BRACKET
DIAGRAM B
WASHER
Assembly:
DIAGRAM A