BMR Suspension BK011 - Manual

Front Strut Mount Bushings
BK011
Required Tools:
Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 14mm, 17mm, 19mm
Sockets – 22mm, 24mm
Installation:
1. Lift vehicle and support with stands under the
rocker jack points or K-member.
2. Remove both front wheels/tires.
3. Remove the (2) Phillips head screws and (10)
plastic clips that retain the plastic inner wheel well.
A small screwdriver will “pop” the clips out by
prying the center of the clip out then removing the
clip. See Image 1.
4. Using a 14mm wrench and a 17mm wrench,
remove the sway bar end links as shown in Image 2
above.
5. Disconnect the rubber brake line from the strut by twisting the line and pulling up. Disconnect the ABS
wire. See Image 3 above.
6. Using a 19mm wrench and 22mm socket, remove the two mounting bolts that retain the strut to the
spindle. See Image 3 above.
7. Pry the plastic cap off the upper strut mount to
expose the retaining nut. See Image 4.