BMR Suspension UTCA034 - Manual

UPPER CONTROL ARM AND MOUNT
UTCA030, UTCA031, UTCA032, UTCA033, UTCA034, UCM002 – 2011-PRESENT FORD MUSTANG
Tools required:
o 3/8”, ½” drive ratchet or impact wrench
o Sockets – 18mm, 21mm deep, 24mm,
25mm, 27mm
o Hydraulic jack and stands or service lift
o Pry-bar
Installation:
1. Remove the lower rear seat cushion to gain access to
the upper control arm mounting bolt. Located
directly above the drivers and passengers side
footwells there is a push release that detaches the
seat cushion. Once each release is popped, the
lower seat cushion can be removed.
2. Using a 24mm socket, remove the large bolt on the
driveshaft tunnel. (IMAGE 1)
3. Lift the vehicle until there is sufficient work space
under the car. Support with jack stands.
4. Using a 21mm deep socket, remove the upper
control arm bolt at the axle. (IMAGE 2)
5. Knock the bolt out, separating the control arm from
the axle. NOTE: it may be necessary to support the
front of the axle to remove tension from the control
arm bolt.
6. Using an 18mm socket and long extension, remove
the (2) remaining upper control arm mount bolts and
remove the upper control arm mount and control
arm out as an assembly. (IMAGE 3)