Sb042 installation instructions – BMR Suspension SB042 User Manual
Page 3
3
SB042 INSTALLATION INSTRUCTIONS
CONTINUED
12. Loosely mount the
provided 7/8” Energy
Suspension bushings to
the BMR axle brackets
then insert the supplied
threaded steel bushing
into the polyurethane
bushings as shown in
IMAGE 7. The threaded
portion should face
inwards as shown. Do
not tighten these
bushings until later.
13. Lift the bar up into the car and connect the
upper part of the end link into the factory
mounting brackets using the factory mounting
hardware as shown in IMAGE 8.
14. Tighten these bolts to 45 ft/lbs. using a 15mm
wrench or socket.
15. After determining which sway bar hole you
want to use, rotate the sway bar up and
connect it to the threaded steel bushings as
shown in IMAGE 9. Use the provided ½” x 2”
bolt, flat washer, and lock washer as shown in
the image. NOTE: make sure you put one of
the supplied ½” washers between the sway bar
and the bushing as shown.
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)