BMR Suspension SB042 - Manual (Page 2)

2
SB042 INSTALLATION INSTRUCTIONS
CONTINUED
8. Install the BMR mounting bracket as shown in
IMAGES 4. If you have BMR CAB005Control
Arm Relocation brackets already installed on
your vehicle, you can simply bolt the bracket in
place using the hardware that was provided
with your Control Arm Relocation brackets
(See images on final page of instructions). If
you do not have BMR Control Arm Relocation
brackets installed on your vehicle, bolt the
BMR sway bar bracket to your axle using the
supplied 12mm x 30mm bolt, washer, and
spacer as shown in IMAGE 4.
9. Once the bracket is installed, tighten the
control arm bolt to 129 ft/lbs. and the damper
bolt to 45 ft/lbs.
10. Proceed to the passenger
side and install the BMR
supplied bracket as
shown in IMAGE 5. This
side does not require a
spacer. Tighten to 129
ft/lbs.
11. Using the provided 1”
Energy Suspension
bushings, connect the
BMR end links to the BMR sway bar as shown in IMAGE 6. Use the provided 3/8” Allen
bolts, nuts, and washers for this connection.