BMR Suspension KM020 User Manual
Page 3
KM018, KM020 TUBULAR K-MEMBER INSTALLATION INSTRUCTIONS
(Continued)
17. Install the OE or BMR A-arms using the supplied aluminum spacers and mounting hardware. The
9/16” x 2.5” bolts go on the rear A-arm mount and the 14mm x 100mm bolts go on the front A-arm
mount. As shown in IMAGE 9, use the lower hole of the front mount. Tighten the front A-arm bolts to
126 ft/lbs. using a 22mm wrench and socket. Tighten the rear to 110 ft/lbs. using a 13/16” wrench and a
7/8” socket. Also see IMAGE 10.
18. Insert the ball joint into the spindle and insert the cross-bolt. Tighten to 40 ft/lbs. using a 15mm wrench
and 18mm socket.
19. If using BMR A-arms, grease the inner bushings and outer ball joint as shown in IMAGE 11.
20. Re-install wheels/tires and lower vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this
vehicle. As such, Buyer assumes all risk of any caused to the vehicle/person during installation or use
of this product.