Www.bmrfabrication.com – BMR Suspension DSL017 User Manual
Page 2
DRIVESHAFT SAFETY LOOP INSTALLATION (Continued)
7. Thread the supplied half nuts and lock washers onto the exposed threads of the transmission mount then tighten to 25 ft/lbs .
8. Install the driveshaft loop by positioning it over the small diameter portion of the driveshaft as in IMAGE 5. Once positioned
insert the supplied 3/8” bolts through the (4) holes. Center the loop over the driveshaft then place a washer and nut on the
bottom side of each bolt. Tighten to 40 ft/lbs. See IMAGE 6. NOTE: if using an aftermarket one-piece driveshaft, it may
be necessary to shim the loop for adequate driveshaft clearance.
9. Lower vehicle.
WWW.BMRFABRICATION.COM
2
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)