BMR Suspension DSL017 User Manual
BMR Suspension For the car
DRIVESHAFT SAFETY LOOP INSTALLATION
DSL017– 2011 Mustang
RECOMMENDED TOOLS:
9/16”
wrench
15mm, 18mm, 9/16” sockets
3/8” drive ratchet or impact
Hydraulic jack and jack stands or Hydraulic service lift
INSTALLATION:
1. Lift vehicle and support safely under frame rails.
2. Support the transmission using a jack stand or jack.
3. As shown in IMAGE 1, loosen the (2) transmission mounting nuts using a 15mm socket.
4. Using a 18mm socket, remove the (4) crossmember bolts as shown in IMAGE 2. Remove the crossmember.
5. Insert the provided transmission mount spacer into the crossmember as shown in IMAGE 3.
6. Hold the BMR driveshaft loop mounting plate and the OE crossmember up into place with the BMR driveshaft loop
mounting plate positioned between the OE crossmember and the floorpan. Insert the provided 60mm bolts and washers then
tighten to 85 ft/lbs. See IMAGE 4.
1