BMR Suspension STB014 - Manual (Page 3)

4 POINT STRUT TOWER BRACE (Cont.)
STB014 – 2010-present Camaro
strut tower brace. Insert the provided 3/8” x 1” bolt but do not tighten. NOTE: Each side is specific and will only fit the
intended side. Adjust the rod end on the other end by turning right or left until the correct length is achieved to line up with
the fender mount.
15. The rod end attaches to the bottom side of the bracket as shown in Image 9 on the previous page. The spacer side of the rod
end points downward. Once the holes are aligned, insert one of the provided 3/8” x 1.75” bolts.
16. Repeat steps 14-15 for the other side.
17. Once all bolts are in position, tighten the fender bolts and 4 point braces.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
3