BMR Suspension SP054 - Manual

LOWERING SPRINGS FOR 2010-PRESENT CAMARO
Part #’s SP019, SP020, SP021, SP022, SP023, SP024, SP025, SP052, SP053, SP054
Required Tools:
Hydraulic jack and jack stands
Spring compressor (optional)
Wrenches: 7mm, 10mm, 15mm, 18mm, 24mm
Sockets: 15mm, 18mm, 24mm
Front Installation:
1. Lift vehicle and safely support it on stands. Remove
the wheel and tire assemblies.
2. Locate the ABS line where it attaches to the strut.
Slide the line out of the bracket as illustrated in
IMAGE 1.
3. Using a 10mm wrench or socket, remove the brake
line retainer bolt where it attaches to the strut. See
IMAGE 2 for reference.
4. Un-bolt the sway bar end link from the strut using a
15mm wrench on the nut with a 7mm wrench in the
center to hold the shaft. See IMAGE 3 for reference.
5. Using a permanent market, grease pencil, or paint pen
mark the strut and spindle along their mating surface.
This mark will be used later during reassembly.
6. Using a 24mm wrench and socket, remove the (2)
large bolts that retain the strut to the spindle. See
IMAGE 3 for reference.