BMR Suspension BK016 - Manual (Page 2)

Rear Subframe Bushing Inserts
BK016 (Continued)
6. Un-plug the fuel pump wiring harness located on the passenger side of the car next to the front
cradle bushing. See Image 4.
7. Twist the rubber brake line while pulling up to “release” it from the bracket attached to the upper
control arm on each side. Image 5 below.
8. Using an 18mm socket or wrench, remove the (2) bolts that hold the caliper to the spindle (Image
6). Remove the caliper and tie it up out of the way with a zip tie.
9. Using Image 7 above as a guide, locate and unplug the ABS plug located above the rear cradle.
10. Detach the emergency brake cables from the spindles. (Image 8)
11. Using an 18mm socket, remove the lower shock
bolts.
12. Support the rear subframe with a hydraulic
jack.
13. Using Image 9 on the following page as a
reference, remove the (4) subframe mounting
bolts using a 21mm socket.
14. Lower the rear subframe assembly
approximately 3 inches to make room for
installing the BMR bushing inserts.
Continued