AirSep MN139-1 - Manual (Page 62)

AirSep ® Corporation
NewLife ® Intensity
- The device is used in accordance with the instructions for use.” If the replacement parts used
for the periodic servicing by an approved technician do not comply with the manufacturer’s
specifications, the latter is absolved from all responsibility in the event of an accident. Do not open
the device whilst in operation: risk of electrical shock. This device complies with the requirements
of the 93/42/EEC European directive but its operation may be affected by other devices being used
close by, such as diathermy and high frequency electro-surgical equipment, defibrillators, short
wave therapy equipment, mobile telephones, CB and other portable devices, microwave ovens,
induction plates or even remote control toys and more generally electromagnetic interferences
which exceed the levels specified by the EN 60601-1-2 standard.
I. descrIPtIoN
The NewLife ® Intensity is an oxygen concentrator designed to satisfy oxygen therapy
prescriptions at home or in the hospital. It provides a continuous flow of oxygen-enriched air by
separating the oxygen and nitrogen contained in ambient air. It can be used either to administer
oxygen with nasal cannulas or another probe or mask type of device.
The NewLife ® Intensity is easy to use and ergonomic. The single flow adjustment knob
allows:
• the device to be easily adjusted to the prescribed flow rate,
• it has a mains alarm and an operating fault alarm
(positive safety type).
Note: the performances described only concern the use of the NewLife ®
Intensity with the accessories recommended by the manufacturer.
I. 1. Front panel (Fig. I. 1)
1 Start/stop push button
2 Circuit breaker
3 Hour meter
4 Humidifier (space reserved)
a) Flask
b) Lid
c) Outlet connector
5 Oxygen-enriched air outlet
6 Flow adjustment knob (l/min.)
7 Safety instructions
8 Oxygen Monitor
1. 2. rear panel (Fig. I. 2)
9 Dust filter
10 Manufacturer’s label
11 Electrical power cable
2-Gb
GB