AirSep MN123-1 F - Manual (Page 33)

MN123-1 rev F 29
Cleaning, Care, and Proper Maintenance
Cabinet
Electrical shock hazard. Turn OFF the unit and disconnect the power cord from the electrical outlet before you
clean the unit to prevent accidental electrical shock and burn hazard. Only your Equipment Provider or a qualified
service technician should remove the covers or service the unit.
Care should be taken to prevent the Oxygen Concentrator and the battery from getting wet or allowing fluids to enter
the unit. This can cause a malfunction or shut down, and cause an increased risk for electrical shock or burns
Do not use liquid directly on the unit. A list of undesirable chemical agents includes but is not limited to the following:
alcohol and alcohol-based products, concentrated chlorine-based products (ethylene chloride), and oil- based
products (Pine-Sol®, Lestoil®). These are NOT to be used to clean the plastic housing on Oxygen Concentrator, as
they can damage the unit’s plastic.
Clean the cabinet, control panel, and power cord only with a mild household cleaner applied with a damp (not wet)
cloth or sponge, and then wipe all surfaces dry. Do not allow any liquid to get inside the device. Pay special
attention to the oxygen outlet for the cannula connection to make sure it remains free of dust, water, and particles.
While using the portable Oxygen Concentrator outdoors with the AC power supply, connect the power supply into a
Ground Fault Interrupted (GFI) outlet only.
Always disconnect AC Power Supply from the wall before disconnecting the AC Power Supply from the oxygen
concentrator.
Always follow the cannula manufacturer’s instructions for proper use. Replace the disposable cannula as
recommended by the cannula manufacturer or your Equipment Provider. Additional supplies are available from your
Equipment Provider.
Keep the FreeStyle unit clean and free from moisture and dust. Clean the plastic housing periodically by wiping with a
lint-free cloth or with a mild household cleaner applied with a damp cloth or sponge. Pay special attention to the
oxygen outlet for the cannula connection to make sure it remains free of dust, water, and particles.
To prevent a voided AirSep warranty, follow all manufacturer’s instructions.