Asante Technologies 35516 - Manual (Page 79)

- 79 -
ip vrrp VRID priority level Sets the priority level of the router within a VRRP VRID
group. The default value is 100.
ip vrrp VRID timers [advertise interval] Configures the interval between successive advertisements
by the master virtual router in a VRRP VRID group.
ip vrrp VRID authentication string Authenticates VRRP packets received from other routers in
the VRID group. If you configure authentication, all routers
within the VRRP VRID group must use the same
authentication string.
The following commands are available under EXEC or Enable mode:
Command Purpose
show vrrp [brief | VRID] Displays a brief or detailed status of one or all VRRP VRID
groups on the router.
show vrrp interface IFNAME [brief] Displays the VRRP groups and their status on a specified
interface.
debug ip vrrp This command helps to debug VRRP operation. If this is
enabled, then VRRP displays the debug messages onto the
console.
5.9 Configuring ICMP Router Discovery Protocol (IRDP)
When IP routing is disabled, you can configure router discovery. The ICMP Router Discovery Protocol (IRDP) allows
the router to dynamically learn about routes to other networks. When operating as a client, router discovery packets
are generated. When operating as a host, router discovery packets are received. The IC35516 IRDP implementation
fully conforms to the router discovery protocol outlined in RFC 1256.
The server/client implementation of router discovery does not actually examine or store the full routing tables sent by
routing devices, it merely keeps track of which systems are sending such data.
5.9.1 Enable IRDP Processing
The only required task for configuring IRDP routing on a specified interface is to enable IRDP processing on that
interface. Use the following command in interface configuration mode.
Command Purpose
ip irdp Enable IRDP processing on an interface.