GE ZV800SJSS - Manual (Page 6)

6
Installation Preparation
REMOVE THE PACKAGING
‡ Remove the duct cover, parts box and other
packaging.
‡ Lift the hood out of the box.
‡ Remove and properly discard the plastic wrapping.
‡ Remove junction box cover.
TOOLS AND MATERIALS REQUIRED (NOT
SUPPLIED )
“ Tape measure
“ Knife
“ Spirit level
“ Wire cutter/stripper
“ Wire nuts
“ Electric drill with 1/8” and 3/8” bits
“ Phillips and flat blade screwdrivers
“ Hammer
“ Pliers
“ Safety glasses
“ Duct tape
“ Tape to mount template
“ Gloves to protect against sharp edges
“ 120V 60Hz. 15 or 20 Amp, 2 wire with
ground Properly grounded branch circuit
“ Strain relief for junction cover
“ 6” round metal duct, length to suit
installation
“ Saw or jig saw
“ Conduit for house wiring
and conduit connector
Measuring Tape
Electric drill
with 1/8”
and 3/8” Bits
Phillips
head
screwdriver
Safety glasses
Gloves Spirit level
Knife
Wire cutter/
stripper
Flat blade
screwdriver
Hammer
Pliers
Duct Tape
Masking tape Wire nuts
2-piece duct
cover
Saw or jig saw
Conduit
Strain relief for
junction box