GE ZV800SJSS - Manual (Page 11)

11
Installation Instructions
4 PREPARE THE HOOD
‡ Remove the hood from the box. Remove packaging
and tape.
‡ Remove one screw on each side of the cover on
the electrical panel. Lift off the cover and set aside
with screws.
‡ Stand the electrical panel upright.
‡ Align the screw holes in the bottom of the panel
with the holes on the base of the hood at the front
side.
‡ Install 3 screws provided.
Remove 2 side
cover screws
Secure
electrical
panel with 3
screws
5 MOUNT THE HOOD
‡ Lift the hood onto the mounting bracket.
‡ Check to be sure it is level.
‡ Install wood screws through the hood and into the
wall on each side of the mounting bracket.
‡ Extend the canopy forward for better access to the
rear mounting screw holes.
‡ Install 2 wood screws or fasteners through the
bottom of the hood into the wall.
Install a wood screw
on each side of the
mounting frame
Install bottom
mounting
screws
:$//02817(',167$//$7,21³9(17('727+(2876,'(
Electrical
panel
Junction box
Mounting
bracket
Inside screw