HP LaserJet Print to Mail Accessories User Manual
Page 12
10 2 Setup
EN
Attaching the HP LaserJet Print to Mail
accessory to the printer
The reversible base of the accessory can be turned upside-down.
This allows the accessory to match the height of a single-tray (1 x
500) HP LaserJet 4050 or 4050N printer or a two-tray (2 x 250)
HP LaserJet 4050T or 4050TN printer.
Note
The HP LaserJet Print to Mail accessory is not designed for use with
a printer with two 500-sheet trays.
1
Remove packing tape from the accessory.
2
Lift the accessory off of the reversible base.
3
Determine whether your printer is a single-tray (1 x 500)
HP LaserJet 4050 or 4050N printer or a two-tray (2 x 250)
HP LaserJet 4050T or 4050TN printer.
4
Check the illustrations embossed on the inside of the reversible
base and flip the base so that the illustration that faces up
matches your printer’s tray configuration.
Figure 5.
Positioning the reversible base
Note
For a two-tray configuration, remove the cutout cover that is taped to
the inside of the reversible base and insert it into the cutout at the upper
corner of the base before you proceed to step 5.
5
Place the reversible base near the rear of the printer.
6
Place the accessory on the reversible base so that the front of the
accessory faces the rear of the printer.
Reversible base setup for
HP LaserJet 4050 or 4050N
Reversible base setup for
HP LaserJet 4050T or 4050TN
printer (1 x 500)
printer (2 x 250)