HP ProLiant DL580 Gen8 Server - Manual (Page 30)

Operations 30
2. After the display fully ejects, rotate the display to the left to view the LEDs.
Remove the SPI board
To remove the component:
1. Power down the server (on page 23 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 23 ).
4. Remove the access panel (on page 27 ).
5. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
("
Processor memory drawer shipping screw locations " on page 28 ).