HP XP Racks - Manual (Page 86)

Description Error code
(SSB2)
The P-VOL is in the process of drive copy for failure assistance. C316
The P-VOL is in the process of drive copy for an SVP request. C317
The P-VOL is terminating the copy task. C318
The P-VOL is in the process of collection copy. C319
The P-VOL is in the process of collection access. C31A
The P-VOL is blocked. C31B
The P-VOL is blocked and impossible to access. C31C
The P-VOL is being formatted. C31D
The P-VOL is read only. C31E
The number of remote paths is 0 (not specified). C320
The number of remote paths is smaller than the minimum required. C321
The DKC type of the primary system does not support Cnt Ac-S. C322
The secondary system's sequence number, SSID, or CU are invalid. C324
The pair cannot be created because the P-VOL is not available for remote copy. C327
The track formats of the P-VOL and the S-VOL do not match. C328
The S-VOL is protected by the Data Retention. C32A
The P-VOL is protected by the Data Retention. C32B
The S-VOL is protected by the Data Retention. C32C
The S-VOL is protected by the Data Retention. C32D
A request for a Paircreate operation was rejected because the specified secondary system is an unsupported
product. C32E
The number of P-VOL cylinders is not the same or smaller than the number of S-VOL cylinders.) C32F
The pair cannot be created or resynchronized because P-VOL and S-VOL capacities are not the same, or
because the S-VOL is in a LUSE configuration. C330
S-VOL cache is unavailable. C332
S-VOL DFW is disabled. C333
The S-VOL is the Cnt Ac-S P-VOL. C335
The S-VOL includes PIN data. C336
The S-VOL is in reserve status. C337
Copy pair cannot be created because of the either of the following reasons. C338
•
The S-VOL is in the intervention-required condition, protected, or unusable status.
• The S-VOL is the S-VOL or Reserved volume of Business Copy, Reserved volume of Auto LUN, or the
volume of Cnt Ac-J pair.
The S-VOL is not available. C339
A request for a Paircreate operation was rejected because the secondary system is a not supported by Cnt
Ac-S. C33A
The corresponding volume cannot be specified as an S-VOL because the volume is used as another pair's
S-VOL. C33B
86 Troubleshooting