HP XP P9000 Application Performance Extender Software - Manual (Page 14)

NOTE:
The controller communicates with the XP and P9500 disk arrays through the command device
names stored in the controller. HP recommends that you add more than one command device
to enable the controller to use an alternative command device, if required.
4. The Command Device Authentication window may be displayed depending on whether authen-
tication is enabled for any one of the selected command devices.
Figure 4 Command Device Authentication
.
Enter the username and password and click Submit.
NOTE:
• The username and password must be the same as specified in Remote Web Console (RWC).
More more information, see Appendix A
• If the password is incorrectly entered, the command device authentication screen continues
to appear until the correct password is entered or Cancel is clicked.
5. Click Next.
The DLOM Settings screen is displayed.
Alternatively, you can select DLOM Settings from the Navigation pane.
Using P9000 Application Performance Extender 14