HP StoreEver DAT Tape Drives - Manual (Page 51)

HP StorageWorks DAT Tape Drives User Guide 51
11 Troubleshooting
Many users can use HP Library & Tape Tools to help them diagnose problems, see ” Diagnostic
tools ” on page 49. We also recommend the detailed troubleshooting guide at
www.hp.com/go/support for comprehensive troubleshooting information.
General Procedure
If a problem occurs, the first step is to try to establish whether the problem lies with the cartridge, the
drive, the host computer and connections, or the way the system is being operated.
‰ Has the system just been installed?
There could be an installation problem:
1. Check through the information in the relevant installation chapter of this guide.
2. Check the power connectors and cabling.
3. Is the SCSI ID correctly set? Is there a SCSI system conflict? Has the SCSI bus been correctly
terminated? See also ” SCSI configuration guide ” on page 57.
4. Check the environmental conditions against the specified limits.
5. Are appropriate drivers and application software installed on the host?
‰ Are you using new cartridges or a different brand of cartridge? Have you been using the
particular cartridge for a very long time?
The problem could lie with the cartridge:
1. Check through the media chapter on page 41.
2. Check that you are using a DDS-labeled cartridge—not a DAT cartridge.
3. Use the correct media type, for example, DAT 72 media with DAT 72 drives.
4. Has the cartridge been write-protected, see ” Write-protecting cartridges ” on page 42?
5. Clean the tape heads with the cleaning cartridge, see ” Cleaning cartridges ” on page 42.
6. Try the operation again.
7. If the problem still occurs, try using a different cartridge.
8. If the problem is still there, the problem probably lies with the drive or the host computer.
‰ Has the drive been moved recently? Have any cables been disconnected and reconnected? Has
the environment changed—unusually hot, cold, damp or dry? Has there been dust or dirt near
the drive. Have reasonable precautions against static been taken?
The problem could lie with the drive:
1. Check the cables and connectors.
2. Clean the tape heads with the cleaning cartridge.
3. If the problem persists, check the environmental conditions against the specified limits (refer to
www.hp.com ). Perhaps move the drive to a more suitable site.