beautypg.com

Connect the power cable, Figure 13 connecting the power cable – HP StoreEver DAT Tape Drives User Manual

Page 28

background image

Installing an external DAT tape drive

28

Connect the power cable

An external HP StorageWorks DAT drive will operate using any voltage in the range 100–240 volts

(0.7 A, 50-60 Hz). No adjustment is needed. To connect your drive to the power supply, proceed

as follows:

1.

Make sure that the drive is switched OFF (O side down). The power switch is on the rear panel.

2.

Plug the power cable securely into the socket on the rear panel of the drive.

3.

Plug the other end of the power cable into the power outlet.

Figure 13

Connecting the power cable

1

power on/off switch

2

power cable

1

2