Scanning errors during alignment, Printhead status messages – HP Designjet Z3200 PostScript Photo Printer series User Manual
Page 154
3.
If the loaded paper is satisfactory, the printer runs the realignment and prints a realignment pattern.
Ensure the transparent window is closed, as a strong light source near the printer during printhead
realignment can affect alignment.
4.
The process takes about six minutes. Wait until the front-panel display shows the process complete
before using the printer.
Scanning errors during alignment
If the alignment process fails, a 'Scanning problems' message appears on the front panel. This means
that the alignment has not completed successfully. Therefore the printer is not aligned and the alignment
should be repeated before printing with good image quality. The problem may be due to:
●
The paper used was not valid, repeat the alignment with valid paper
●
Printhead health problems, clean printheads, see
Clean the printheads on page 139
●
The alignment was done with the transparent window open, repeat the alignment with the window
closed
If the problem persists after using valid paper, cleaning the printheads and keeping the window closed,
there may be a failure in the scanning system needing reparation or the printheads, although clean, may
not work and need to be replaced.
Printhead status messages
These are the possible printhead status messages:
●
OK: The printhead is working normally, with no known problems
●
Missing: There is no printhead present, or it is not correctly installed in the printer.
●
Test printhead separately: You are recommended to test the printheads individually to find the
failing printhead. Remove all the printheads and insert them alone one by one, closing the latch
and the carriage lid after every insertion. The front-panel display indicates the failing one showing
the reseat or replace message.
●
Reseat: You are recommended to remove the printhead and then reinsert it. If that fails, clean the
electrical connections, see
The front-panel display recommends reseating or replacing a
. If that fails, replace the printhead with a new printhead, see
and
●
Replace: The printhead is failing. Replace the printhead with a working printhead of the correct
type for your printer, see
and
.
●
Replacement incomplete: A printhead replacement process has not completed successfully, re-
launch the replacement process and let it finish completely (it is not needed to change the
printheads).
●
Remove: The printhead is not a suitable type for use in printing.
144 Chapter 13 Troubleshooting ink cartridge and printhead issues
ENWW
In
k sy
st
em
iss
u
es