HP StoreEver DAT Tape Drives - Manual (Page 31)

2. Connect the SAS data cable to the tape drive, as illustrated below. Connect a spare power cable
from the server's internal power supply to the power connector on the SAS data cable.
Figure 11 Connecting cables to the DAT 320 tape drive
.
Figure 12 Connecting cables to the DAT 160 tape drive
.
2. Power connector 1. SAS connector to tape drive
3. This will leave unused SAS cabling within the server because the other SAS connector is not
required in this configuration. If you are using the supplied SAS cable, do NOT remove tie wrap
or cover on the spare connector. If you are using the Infiniband cable, coil and secure the unused
cabling so that it does not interfere with other components inside the server.
4. Now go to “ Secure the drive ” on page 36.
Option 3: Connect cable to port on host SAS controller and replace existing
SAS cable
The following instructions are valid for some HP ProLiant servers, but ONLY IF recommended as an
option on
http://www.hp.com/go/connect .
DAT SAS Tape Drives 31