HP StoreEver DAT Tape Drives - Manual (Page 27)

Figure 6 Selecting the correct cabling option for an internal tape drive
.
IMPORTANT:
You may damage your server configuration, if you follow the wrong installation instructions when
connecting to the host SAS controller. Always refer to
http://www.hp.com/go/connect to find out
which cabling option is appropriate for your combination of server and SAS host bus adapter. This
will also advise about any possible impact on connectivity to disk drive bays. Remember you need to
address two questions if connecting to the host SAS controller:
• What type of connector is on the server, Infiniband-style or Mini-SAS?
• What is the server's current SAS configuration? How will the loss of connectivity to one hard disk
drive bay affect it?
To use go/connect:
1. Select tape backup and navigate down to the Hardware Compatibility table for your make of
server.
2. The server/tape drive matrix shows top-level compatibility. Be sure to click on the box for your
combination of server and tape drive to display a further page with detailed connectivity inform-
ation. The QuickSpecs link takes you to the page that contains SAS cable kit options.
DAT SAS Tape Drives 27