HP Insight Diagnostics Software - Manual (Page 24)

Click Start Drive Identity LED to identify the specific hard drive in the computer that may contain
the volume. The hard drive LED indicates the location of the volume as follows:
•
A SCSI hard drive containing the logical volume flashes the hard drive LED.
•
A SATA or SAS hard drive containing the logical volume illuminates a blue hard drive LED.
The LED remains illuminated or continues to flash until you click Stop Drive Identity LED.
In cases where the Identity LED is unavailable, the drive may be identified by its enclosure, bay,
and serial number, which are displayed in the Diagnosis result.
Figure 13 Test status
Viewing offline test status
The progress and status of offline quick, complete, or custom testing appears on the Status tab as
follows:
•
Device displays the specific device being tested.
•
Test displays the specific test running.
•
Status displays the test results as follows:
Canceled: The test did not complete or was canceled. ◦
◦ Passed: The test passed, and the device is operating within specifications.
◦
Failed: The device failed the test, or the test itself failed. A failure indicates that additional
testing should be performed on the device.
◦ Further Troubleshooting Required: A communication problem exists that could be related
to the health of the device. Perform additional troubleshooting procedures to determine
the problem or use the Custom test option on the Test tab to retest the device.
◦ Abnormal termination: The test terminated abnormally.
24 Using HP Insight Diagnostics