HP RDX Removable Disk Backup System - Manual (Page 13)

No mounting hardware used
1. Use the M3 screws provided with the server or the M3 screws provided in the accessory kit.
Check that the holes in the chassis are aligned with the holes in the sides of the drive and use
a regular Phillips screwdriver to secure the M3 screws, as shown in the figure below.
Figure 8 Securing drive, no mounting hardware used
1. M3 screws, supplied
2. Ensure blanking plates are in place over empty bays and replace the cover on the server or
workstation.
Secure the RDX Removable Disk Backup System 13