HP rp5700 Point of Sale System - Manual (Page 10)

2 Setting Up the Printer
Checking the Packing List
Save the packing materials in case you need to repack the printer for shipping or storage. Before
installation, check that all the items listed below have been shipped.
● Printer
● Starter roll of receipt paper
● Test printout
● USB power cable (some models); power cable (some models)
● HP Point of Sale System Software and Documentation CD
Loading or Changing the Receipt Paper
Before setting up the receipt printer, ensure power is turned off to the printer, POS computer and
other attached devices.
CAUTION: You must use qualified paper rolls with the HP printers. The list of qualified paper is in
Technical Specifications on page 23 . Using unqualified paper may void the warranty.
You will later use the same procedure to change the receipt paper as you will to load it during
installation. The minor difference is noted in the directions below.
NOTE: The printer must be set to the paper type being used for proper operation. This can be done
by sending the command 1D 81 m n or by a selection in the configuration menu. To change the paper
type in the configuration main menu select Set Paper Type and make selections. Refer to
Operating
the Printer on page 10 for information on entering the configuration menu.
1. Open the receipt cover by pushing up on each side of the cover (1) until it unsnaps.
4 Chapter 2 Setting Up the Printer ENWW