HP Integrity NonStop H-Series - Manual (Page 59)

Troubleshooting
9840 (CT9840FC-3) Installation and User’s Guide for the NonStop S-Series Enclosure— 524959-003
A- 5
Operator Panel Messages
DumpAgain? Drive detected the same CHK
(FSC) within one minute. Go to “‘Handling a Dump Again?’
Indication” in Appendix A.
“Exp ClCart” Cleaning cartridge is used up. Replace the cleaning cartridge.
FFFF:Dmp Y Alternates with corporate ID at
completion of IPL, where
FFFF=FSC of last dump date
collected, Y=number of
uncollected dumps in EEPROM. Optionally move dump/s to host
or tape: see various dump
instructions in section 5 or 7.
Fix_CfgErr Upon IPL, configuration
checksum doesn’t match. Go to “What to do if the Fix
CfgErr Occurs” in Appendix A.
INIT (FSC) Initialization error. Try IPL: if that fails, replace drive.
IPL Pend IPL Pending is displayed for one
second when IPL is pressed. Wait until IPL completes
automatically.
Load CC The common controller code is
loading. No user action is necessary.
Loading Tape cartridge is being loaded. No user action is necessary.
Load ESCON Normal display during boot. Wait for IPL to complete.
Load (FSC) Load/unload operation has failed. If another tape also fails load, IPL
drive. If failure persists, replace
drive. If another tape works, tape
is suspect.
Load SCSI Normal display during boot. Wait for IPL to complete.
Locating Drive is doing a high speed seek. No user action is necessary.
Memory Err RAM failed during IPL. IPL again. If that fails, replace
drive.
NT Ready F Non-write protected tape is in
process of manual unload. Wait until unload operation
completes.
NT Ready U Write protected tape is in process
of manual unload. Wait until operation completes.
Online The drive is operational. No user action is necessary.
Power Fail Power supply has failed. Replace power supply.
Reading The drive is in the read mode. No user action is necessary.
Ready F Loaded tape is file protected. Operator discretion.
Ready U Loaded tape is not file protected. Operator discretion.
Rewinding The drive is rewinding. No user action is necessary.
Save Fails New configuration cannot be
saved. Replace drive.
Table A-1. Operator Panel Displays
Display Probable Cause Recommended Action