HP Integrity NonStop H-Series - Manual (Page 56)

Troubleshooting
9840 (CT9840FC-3) Installation and User’s Guide for the NonStop S-Series Enclosure— 524959-003
A- 2
Operator Panel Messages
6. Manual Unload Device
7. Unload Switch
8. Operator Display
9. Menu Switch
10. Select Switch
11. Tape Cartridge Entry
This table explains indications shown by the Power and Service indicators.
These indications do not cause a specific error message on the alphanumeric
display.
Table A-1 on page A-3 provides information on specific error conditions.
Operator Panel Messages
Table A-1 on page A-3 provides and alphabetical list of operator panel
messages and recommended actions. The notation FSC stands for a four-digit
alphanumeric fault symptom code. The code itself is not important for identifying
the error type.
Service Power Meaning; Action
Off On Normal operation; take no action.
Flashing after
collection is done On or flashing Drive error recovered to EEPROM;
IPL drive to see if the problem
repeats. If the problem repeats, collect
dump data and/or replace drive.
Off or flashing Flashing while
action takes place Drive error; automatically run an IPL
or power on initiated.
Off or flashing Flashing constantly,
meaning it does not
exit IPL mode Drive failed proper power on; replace
drive.
On On Drive failed; IPL drive to see if
problem repeats. If problem repeats,
replace drive.
Note. For removal and replacement of a drive, call your service provider or refer to Section 6
Servicing the Tape Drive . All other procedures referred to in this table follow the table.