HP Ethernet 10Gb 2-port 530T Adapter User Manual
Page 35

Scripting mode 35
;Configure Initiator IP address:
IP Address = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current =
::
;Configure IP Subnet Mask Prefix Length:
Subnet Mask Prefix =
;Configure Default Gateway IP Address:
Default Gateway = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current =
::
;Configure Primary DNS IP Address:
Primary DNS = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current =
::
;Configure Secondary DNS IP Address:
Secondary DNS = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current =
::
;Configure iSCSI Name:
iSCSI Name = < String (0 to 128 Chars) > ; current = iqn.1995-
05.com.bro
adcom.iscsiboot
;Configure CHAP ID:
CHAP ID = < String (0 to 128 Chars) > ; current =
;Configure CHAP Secret:
CHAP Secret = < String (12 to 16 Chars) > ; current =
[1st Target Parameters]
;Enable/Disable Target Establishment:
Connect = < Enabled | Disabled > ; Current = Disabled
;Configure Target IP Address:
IP Address = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current = ::
;Configure Target TCP Port Number:
TCP Port =
;Configure Target Boot LUN Number:
Boot LUN =
;Configure iSCSI Name:
iSCSI Name = < String (0 to 128 Chars) > ; current =
;Configure CHAP ID:
CHAP ID = < String (0 to 128 Chars) > ; current =
;Configure CHAP Secret:
CHAP Secret = < String (12 to 16 Chars) > ; current =
[2nd Target Parameters]
;Enable/Disable Target Establishment:
Connect = < Enabled | Disabled > ; Current = Disabled
;Configure Target IP Address: