HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 27)

Scripting mode 27
Comments
;***********************************************************************
;CCMCFG32 v7.8.21 - Comprehensive Configuration Management
;Copyright (C) 2000-2013 Broadcom Corporation
; Dumping Configuration Parameters of Device [00:10:18:6F:D2:74] to
outfile.txt
;***********************************************************************
Characters after a semicolon are treated as comments.
Device block
[Device Parameters]
MAC Address = 00:10:18:6F:D2:74
PCI Function Number = 01:00:00
Device Type = BCM57712
Vendor ID = 0x14E4
Device ID = 0x1662
Subsystem Vendor ID = 0x14E4
Subsystem Device ID = 0x1213
Inside the [Device Parameters] block, only and keys are used to
specify device scope. The rest of lines are informational descriptions. For details about the device scope
specification, see "Operation device scope (on page 26 )."
Section declaration head
The section head format is [section
[Section MBA Configuration Menu]
Option ROM = Disabled
Boot Protocol = Preboot Execution Environment (PXE)
Boot Strap Type = Auto
Hide Setup Prompt = Disabled
Setup Key Stroke = Ctrl-S
Banner Message Timeout = 5 Seconds
Link Speed = 10Gbps
Pre-boot Wake On LAN = Disabled
VLAN Mode = Disabled
VLAN ID = 1
Boot Retry Count = 0
Group declaration head
The group declaration head format is []. In the following example, [General
Parameters] is the group declaration head and [Section iSCSI Boot Main Menu] is the section
declaration head. The group head is optional depending on whether the configuration is hierarchical. The
MBA configuration section does not have a group head, but other sections have group heads.
[Section iSCSI Boot Main Menu]