HP Scanjet N6010 Document Sheet-feed Scanner - Manual (Page 24)

LED indication Scanner action or condition
The Power LED
is lit with a steady,
dim amber light.
The scanner is in Power Save mode.
The Power LED
is lit with a steady
green light.
The scanner is on and ready to scan.
The Power LED
blinks green at a
medium speed.
The scanner is scanning an original.
Both LEDs are off There is no power to the scanner.
Scanner initialization or hardware problems
This section contains solutions for initialization and hardware problems.
●
Reset the scanner
● Scanner has stopped working correctly
● Check the cables
Reset the scanner
If you receive an error message similar to “Scanner initialization failed” or “Scanner not
found” when trying to use the scanner, follow these steps:
1.
Close the scanning software, if it is open.
2. Disconnect the USB cable that connects the scanner to the computer.
3. Turn the scanner off.
4. Shut down the computer operating system, turn the computer off, wait 60 seconds,
and then turn the computer back on.
5. Turn the scanner on.
6. Reconnect the USB cable that connects the computer and the scanner, making sure
that the USB cable is connected to the back of the scanner correctly.
Scanner has stopped working correctly
If the scanner stops scanning, follow these steps. After each step, start a scan to see if
the scanner is working. If the problem persists, proceed with the next step.
1.
A cable might be loose. Ensure that both the USB cable and power supply are
properly connected.
2. Unplug the power cable from the power source, wait 60 seconds, and then plug it
back in.
3. Restart your computer.
Chapter 4
(continued)
22 HP Scanjet N6010 Sheetfeed Document Scanner