HP Netserver E Server series - Manual (Page 68)

Chapter 4 Using HP Support Anywhere
64
Double-clicking the Auto Alert icon displays a panel with Support Anywhere
version information.
NOTE If you close the Auto Alert service at the Support Anywhere
Client, you will no longer be notified of alarms on your HP
NetServers.
HP Support Anywhere Auto Alert
Auto Alert is a service that monitors the operating environment of HP NetServers
and generates notifications and alarms based on factory-defined error thresholds.
The changes are identified by SNMP alarm agents which, during installation, are
installed on all participating HP NetServers.
In the course of normal operations, when a condition changes that might effect
server function, an Auto Alert notification is immediately sent over the network
to a designated client workstation.
Auto Alert alarms and notifications are triggered by changes in disk volume
(capacity), Network Interface Card (NIC) status, and predictive SCSI drive
failure.
Figure 14: Example of a Notification Sent to the Support Anywhere Client