Checking the error led, Connecting the network cable – HP UPS Management Modules User Manual

Page 20

Text mode
Original mode

Installing the HP UPS Management Module 20

Checking the Error LED

If the Error LED illuminates red or flashes red, see the "Troubleshooting (on page

)" section for more

information.

Connecting the network cable

Connect a standard Ethernet cable between the network connector on the management module and a
network jack.

This connection is used to access the management module remotely through telnet or the web interface.
The management module also uses the network connection to communicate to the configured agents and
to facilitate SNMP-based monitoring.