HP NC373F PCI-E Multifunction 1000SX Gigabit Server Adapter - Manual (Page 9)

Installation and configuration 9
mezzanine adapters. For embedded adapters, both can be updated and co-exist but at any point of time
only one can be used.
The HP iSCSI option ROM offers the following:
• PCI compatible option ROM header that identifies the ROM code to BIOS
• System BIOS Interrupt 13 Disk Interface that translates BIOS disk I/O to iSCSI
• HP iSCSI Data Mover that performs iSCSI PDU Protocol
• Binary image of an UNDI implementation
• Firmware component to perform TCP/IP encapsulation
Updating the iSCSI boot option ROM
The HP NC-Series Broadcom Online Firmware Upgrade Utility for Linux (CP00xxxx.scexe) upgrades the
iSCSI boot option ROM firmware image on all iSCSI-capable adapters:
• HP NC370x Multifunction Gigabit Server Adapter
• HP NC371x Multifunction Gigabit Server Adapter
• HP NC373x Multifunction Gigabit Server Adapter
• HP NC374x Multifunction Gigabit Server Adapter
• HP NC380T Multifunction Gigabit Server Adapter
• HP NC370i Multifunction Gigabit Server Adapter
• HP NC373i Multifunction Gigabit Server Adapter
• HP NC373m Multifunction Gigabit Server Adapter
Updating using CP00xxxx.scexe
To update the iSCSI boot option ROM on all iSCSI capable adapters, HP NC-Series Broadcom Online
Firmware Upgrade Utility for Linux called CP00xxxx.scexe is provided in the \linux\fwupgrade folder in
the HP ProLiant Networking SoftPaq. Two components are provided in the directory, one for x86 and one
for x86_64. Read the CP00xxxx.txt file to determine the component needed for the required system
architecture.
The HP NC-Series Broadcom Online Firmware Upgrade Utility for Linux does not install iSCSI firmware. It
only upgrades iSCSI if iSCSI is already installed on the adapter. It can also update to iSCSI if PXE is
already installed.
Updating iSCSI option ROM
To update to latest iSCSI boot option ROM image, complete the following steps.
1. The firmware utility requires the adapter interface to be up and running. Bring up a network adapter
interface using the following command:
# ifup ethx
or
# ifconfig ethx up
2. Update the firmware using the following command:
#./CPXXXXXX.scexe -s
Replacing PXE option ROM