HP XP RAID Manager Software - Manual (Page 71)

If this restriction is exceeded, then use a different SCSI path for each instance. For example, the
command devices for the following figure would be:
•
HP-UX:
HORCM_CMD of HORCMINST0 = /dev/rdsk/c0t0d1 HORCM_CMD of HORCMINST1 = /dev/rdsk/c1t0d1
•
Solaris:
HORCM_CMD of HORCMINST0 = /dev/rdsk/c0t0d1s2 HORCM_CMD of HORCMINST1 = /dev/rdsk/c1t0d1s2
For Solaris operations with RAID Manager version 01-09-03/04 and higher, the command
device does not need to be labeled during format command.
•
AIX:
HORCM_CMD of HORCMINST0 = /dev/rhdiskXX HORCM_CMD of HORCMINST1 =
/dev/rhdiskXX
where XX = device number assigned by AIX
•
Tru64 UNIX:
HORCM_CMD of HORCMINST0 = /dev/rrzbXXc HORCM_CMD of HORCMINST1 =
/dev/rrzbXXc
where XX = device number assigned by Tru64 UNIX
•
Windows 2012/2008/2003/2000:
HORCM_CMD of HORCMINST0 = \\.\CMD-Ser#-ldev#-Port# HORCM_CMD of HORCMINST1 =
\\.\CMD-Ser#-ldev#-Port#
•
Windows NT:
HORCM_CMD of HOSTA = \\.\CMD-Ser#-ldev#-Port#
HORCM_CMD of HOSTB = \\.\CMD-Ser#-ldev#-Port#
HORCM_CMD of HOSTC = \\.\CMD-Ser#-ldev#-Port#
HORCM_CMD of HOSTD = \\.\CMD-Ser#-ldev#-Port#
•
Linux, z/Linux:
HORCM_CMD of HORCMINST0 = /dev/sdX HORCM_CMD of HORCMINST1 = /dev/sdX
where X = device number assigned by Linux, z/Linux
•
IRIX64:
HORCM_CMD for HOSTA (/etc/horcm0.conf)... /dev/rdsk/dks0d0l1vol or
/dev/rdsk/node_wwn/lun1vol/c0p0
HORCM_CMD for HOSTB (/etc/horcm1.conf)... /dev/rdsk/dks1d0l1vol or
/dev/rdsk/node_wwn/lun1vol/c1p0
Examples of RAID Manager configurations 71