HP LaserJet 5200 Printer series - Manual (Page 174)

4. Turn over the stack in the tray. Also, try rotating the stack 180°.
5. Make sure that the type and quality of the media you are using meet HP specifications. (See
Paper specifications .)
6. Make sure that the environmental specifications for the printer are being met. (See Operating
environment .)
Curl or wave
1. Turn over the stack in the tray. Also, try rotating the stack 180°.
2. Make sure that the type and quality of the media you are using meet HP specifications. (See
Paper specifications .)
3. Make sure that the environmental specifications for the printer are being met. (See Operating
environment .)
4. Try printing to a different output bin.
5. If media is lightweight and smooth, open the CONFIGURE DEVICE menu at the printer control
panel. On the PRINT QUALITY submenu, select FUSER MODES, and then select the media
type you are using. Change the setting to LOW, which helps reduce the heat in the fusing
process. (See
Print Quality submenu .) You must also set the type of media for the tray you are
using. (See Controlling print jobs .)
Wrinkles or creases
1. Print a few more pages to see if the problem corrects itself.
2. Make sure that the environmental specifications for the printer are being met. (See Operating
environment .)
3. Turn over the stack in the tray. Also, try rotating the stack 180°.
4. Make sure that media is loaded correctly and all adjustments have been made. (See
Configuring trays .)
160 Chapter 7 Problem solving ENWW