ADTRAN TRACER Protection Switch - Manual (Page 7)

7
6b
Connecting the Antenna Interfaces (TRACER 4103 and 4203 Systems)
1. Connect the Antenna interface (N-Type connector) of the MAIN TRACER 4103/4203 (labeled 1 below) to the MAIN RF interface (SMA
connector) of the TRACER MPS (labeled 2 below) using a male N-Type to male SMA cable.
2. Repeat Step 1 to connect the Antenna interface (N-Type connector) of the STANDBY TRACER 4103/4203 to the STANDBY RF inter-
face (SMA connector) of the TRACER MPS (labeled 3 below).
T
R
A
C
E
R
MAIN
STANDBY
OUT
NO COM NC MN COM SB
IN
ALARMS DC POWER RF
ANTENNA TO DTE RS-232
MONITOR
T1B T1A
MAIN
TRACER
STANDBY
TRACER
MONITOR
POWER MODULE
USE COPPER
CONDUCTORS ONLY OUT IN IN OUT B A B A
MAIN
STAND BY
T1B T1A
MAIN UNIT Antenna Interface 1
2
3 TRACER MPS STANDBY
Antenna Interface
4 MAIN UNIT Antenna Interface
TRACER MPS MAIN
Antenna Interface
3. Connect the TRACER MPS Antenna interface (N-Type connector, labeled 4 above) to the customer provided antenna using antenna
feedline cabling. Refer to the appropriate TRACER User Manual for a detailed discussion on link planning, antenna loss/gain, and
antenna alignment.