HP ProLiant BL465c Server Blade - Manual (Page 25)

4. Add the following registry value:
Value name: DisableStrictNameChecking
Data type: REG_DWORD
Radix: Decimal
Value: 1
5. Close the Registry Editor.
For more information about these steps, see the Microsoft Knowledge Base Item 281308 on the
Microsoft website .
IPv6 addresses can be passed to HP SUM in command line arguments or using the HP SUM user
interface. In the HP SUM user interface, you can add a remote host on an IPv6 network by either
entering the DNS name of the IPv6 target server or by selecting the IPv6 address button and entering
the IPv6 address. HP SUM supports both the short-name and full IPv6 notation. You do not need
to add the optional interface number when you enter the address.
If you cannot connect to the target server or receive a Discovery failed message when executing
HP SUM in an IPv6 environment, see
“Configuring IPv6 networks with HP SUM” (page 26) .
After you connect to the target server, all other HP SUM functions work identically. Log files for
IPv6 hosts are stored with all other HP SUM files in the \CPQSYSTEM\hp\log\
directory.
Configuring IPv6 for Windows Server 2008
HP SUM provides the most robust support for remote deployment when using Windows Vista as
a client to Windows Server 2008-based servers. Using HP SUM in this environment enables you
to use all the capabilities of IPv6 including link-local, site-local, and global IP addresses for both
local and remote target servers. Windows Vista, when used as a client to run HP SUM to remote
Windows Server 2008 operating systems or as a target operating system on HP Workstation server
blades, provides the infrastructure that supports full IPv6 deployment of software and firmware
updates from HP SUM.
NOTE: Windows XP clients are not supported in IPv6 networks for HP SUM deployment.
IPv6 addresses can be passed to HP SUM in command line arguments or using the HP SUM user
interface. In the HP SUM user interface, you can add a remote host on an IPv6 network by either
entering the DNS name of the IPv6 target server or by selecting the IPv6 address button and entering
the IPv6 address. HP SUM supports both the short-name and full IPv6 notation. You do not need
to add the optional interface number when you enter the address.
If you cannot connect to the target server or receive a Discovery failed message when executing
HP SUM in an IPv6 environment, see
“Configuring IPv6 networks with HP SUM” (page 26) .
After you connect to the target server, all other HP SUM functions work identically. Log files for
IPv6 hosts are stored with all other HP SUM files in the \CPQSYSTEM\hp\log\
directory.
Configuring IPv6 for Linux
HP SUM leverages the IPv6 capabilities of Linux as provided by the Red Hat Enterprise Linux and
Novell SUSE Linux Enterprise Server products. Using HP SUM in this environment enables you to
use all the capabilities of IPv6 including link-local, site-local, and global IP addresses for both local
and remote target servers. Remote target servers must have the iptables-ipv6 RPM installed before
targeting them from HP SUM. Failure to install the iptables-ipv6 RPM prevents HP SUM from opening
the communications port needed to send data to the initiating Linux workstation. You can disable
the Linux firewall to allow HP SUM to work, but the Linux server becomes vulnerable to attack.
For information on how to setup IPv6 in a Linux environment, please see the Linux IPv6 How To
website at
Linux IPv6 How-To .
Configuring IPv6 networks 25