HP ProLiant DL380 Server - Manual (Page 43)

All other controllers
without
battery-backed write
cache All other controllers
with battery-backed
write cache RA4x00 with 48MB
cache RA4x00 with 16MB
cache Read:write ratio
– – + + 80:20
– + – – 75:25
– – + + 70:30
– – + + 60:40
– + + + 50:50
– – + – 40:60
– – + – 30:70
– + + – 25:75
– – – + 0:50*
– – + – 0:75*
– + – – 0:100
* The cache ratio percentages do not total 100 in these cases because the additional 16-MB or
48-MB cache modules are not used. Only the battery-backed write cache is used.
RebuildPriority, ExpandPriority
This option has three possible values: Low, Medium, and High.
SSPState
There are two settings for this option: Enable and Disable. If you do not specify a value for the
SSP State, the existing setting remains unchanged.
NOTE: The SSPState option is valid only for controllers that enable SSP on a controller basis,
such as the MSA1000 or the Smart Array Cluster Storage controllers. RA4x00 controllers support
SSP that is enabled on a logical drive basis, and use the LogicalDriveSSPState option
(page 46)
instead.
If you enable SSP, you must also specify an adapter for one or more logical drives by using the
SSPAdaptersWithAccess option
(page 47) . Otherwise, SSP is automatically disabled.
SurfaceScanDelay
Enter a number between 1 and 30 to specify the duration of the surface scan delay in seconds.
Video performance options
To optimize the controller performance for video, set values for the following options as indicated:
DPOEnable = No
ElevatorSortEnable = Yes
IRPEnable = No
In addition, do the following:
•
Set the MNPDelay to any integer value from 1 to 60 (units are minutes). If you want to disable
this option, set a value of zero instead.
•
Set the QueueDepth to any integer value from 2 to 32, or to Auto.
Using HPACUSCRIPTING 43