HP PCIe U320 SCSI Host Bus Adapter - Manual (Page 26)

Using the Configuration Tool
NOTE:
The HP StorageWorks U320e SCSI Host Bus Adapter is designed to operate properly using factory
settings. Entering invalid or incorrect settings when using an NVRAM configuration utility, such as the
ATTO Configuration Tool, may cause your host adapter to function incorrectly.
CAUTION:
Back up system data before installing or changing hardware configurations.
To start the Configuration Tool:
1. Locate the application icon in the folder you created during installation.
2. Double-click the icon to start the application.
The main screen has three windows: Device Listing, Configuration Options, and Status.
Navigating the ATTO Configuration Tool
The left side of the Device Listing window lists all devices currently connected to the system.
• Expand the device tree by clicking the + to reveal additional detail on connected devices.
• Collapse the branch by clicking the –.
Information and options for a device highlighted in the device listing are presented in the Configuration
Options window in the right window pane.
The currently selected device determines the tabs and panels shown in the Device Listing. The
Table 3
specifies the tabs that display for the each device type.
Table 3 Tabs displayed by device type
Tree Node Tabs displayed
Adapter Basic Info, Flash, Advanced
Channel NVRAM, PCI info
SCSI Devices Basic Info
Local Host Basic Info
The following tabs display in the Configuration Options window when you select a specific adapter
in the Device Listing window:
• The Basic Info tab provides basic information about the device currently highlighted in the device
listing; no changes are possible from this screen or information about the host when the Local
Host is highlighted.
• The Flash tab provides information about the current revision of the flash firmware loaded on the
highlighted host adapter.
Click the Browse button at the bottom of the tab to search for new flash files on your system. Flash files
have filenames of the form FlashBundle_2004_02_20.21P.
• The Advanced tab is not supported for the HP StorageWorks U320e SCSI Host Bus Adapter
and will display a message.
When you select a specific channel under an HP StorageWorks U320e SCSI Host Bus Adapter or ATTO
host adapter in the Device Listing, the NVRAM panel displays the NVRAM parameters applicable
26 Configuration tool