HP PCIe U320 SCSI Host Bus Adapter - Manual (Page 16)

b. Use a small, flat screwdriver to remove the four stand-offs on the external connectors, as
shown in Figure 3 .
11315
Figure 3 Removing the stand-offs
c. Remove the bracket and replace it with the low-profile bracket. Verify that the new bracket
is oriented correctly, as shown in Figure 4 .
11316
Figure 4 Card with low-profile bracket
d. Replace the four stand-offs to secure the bracket to the board.
e. Attach the two screws to the high-profile bracket in case you need the larger bracket to install
the adapter in another server.
Preparing the server
To prepare the server for the new adapter:
1. Back up all data.
2. Perform a normal system shutdown.
3. Power down the server.
4. Power down all peripheral devices that are connected to the server.
5. Unplug the server’s AC power cords from the power outlet and then from the server.
6. Disconnect all peripheral devices from the server.
16 Installation