Set triggering using scpi commands – Agilent Technologies AGILENT U2761A User Manual
Page 108

90
U2761A User’s Guide
2
Features and Functions
Set Triggering Using SCPI Commands
Example 1
-> *CLS
; *RST
//To reset the U2761A to
default power
-on state,
this command can be
ignored if this operation
is not required.
-> FUNC SIN
//Sets the carrier waveform
to Sine wave.
-> VOLT 5 VPP
//Sets the output amplitude
to 5 Vpp.
-> VOLT:OFFS 0
//Sets the output offset to
0.
-> SWE:STAT ON
//Enables frequency sweep.
-> FREQ:STAR 500
//Changes the start
frequency to 500 Hz.
-> FREQ:STOP 10000
//Changes the stop
frequency to 10 kHz.
-> SWE:SPAC LIN
//Changes the sweep mode
to Linear.
-> SWE:TIME 2
//Changes the sweep time
to 2 s.
-> TRIG:SOUR IMM
//Changes the sweep trigger
source to Internal.
-> OUTP:TRIG ON
//Turns on the trigger
output.
-> OUTP:TRIG:SLOP POS
//Outputs the trigger on a
rising edge.
-> OUTP ON
//Turns on output.
- HP 16500B (38 pages)
- E4400-60230 (18 pages)
- Option H48 Multiport Test Set Z5623A (138 pages)
- hard disk drive kit e5052-90202 (13 pages)
- FIXTURE U7242A (10 pages)
- FS2010 (36 pages)
- USB/GPIB Interface Converter 82357A (70 pages)
- 34399A RS-232 (3 pages)
- 1100 Series (28 pages)
- N9340A (161 pages)
- HSSI WanProbe J3916A (179 pages)
- 37907A (16 pages)
- N1022A (24 pages)
- Agilent E6474A (184 pages)
- 82357B (34 pages)
- Agilent E1345A (5 pages)
- 85225F (148 pages)
- 8510C (16 pages)
- Wireless Network Optimization Platform E6474A (194 pages)
- J3919A (189 pages)
- 85032B/E 50 (55 pages)
- 8510 (32 pages)
- J6800A (16 pages)
- E6474A (14 pages)
- N2610A (248 pages)
- N6314A (7 pages)
- 85107B (20 pages)
- 8753ET (28 pages)
- N9360A (44 pages)
- Agilent 82350B (51 pages)
- Agilent 4396B (124 pages)
- LXI (8 pages)
- E1439 (246 pages)
- U2802A (67 pages)
- Agilent Hard Disk Drive Kit E5071BU (12 pages)
- U2781A (47 pages)
- E1301B (244 pages)
- Multiple Channel Controller 85330A (166 pages)
- E6701A (32 pages)
- N2620A (279 pages)
- E5810A (159 pages)
- E5805A (47 pages)