Avaya M770 - Manual (Page 12)

Chapter 1 Quick Start
2 Avaya M770 User’s Guide
Note: You must install the depth-adjusting plates before installing any modules.
To install the plates perform the following steps:
1
When facing the hub, align each plate so that the narrow flange is toward the
rear of the hub, facing out. See Figure 1.1.
2 From inside the hub, screw on the 4 flat-headed screws to secure the plate to the
side of the hub.
Figure 1.1 Attaching the Depth Adjusting Plate
Decorative Edge Panels
The two plastic side-panels can be removed to allow access to the screw holes.
Simply unclip the panels and replace them. The panels are interchangeable.