Ampro Corporation COM 830 - Manual (Page 78)

Chapter 4 BIOS Setup Description
72 Reference Manual COM 830
Remote Access Configuration Submenu
Feature Options Description
Remote Access Disabled
Enabled
Enable/Disable the BIOS remote access feature.
Note: If the systems serial ports are disabled in the 'I/
O Interface Configuration' submenu, then Serial
Redirection is disabled and 'Remote Access
Configuration' menu is unavailable to the users.
Serial Port Number COM1
COM2 Select the serial port you want to use for console
redirection.
Note: Only enabled serial ports are presented as an
option.
Serial Port Mode 115200 8,n,1
57600 8,n,1
19200 8,n,1
Select the baud rate (transmitted bits per second) you
want the serial port to use for console redirection.
Note: The terminal program used with Serial
Redirection must be set to use exactly the same set of
communication parameters.
Flow Control None
Hardware
Software
Select the flow control for Serial Redirection.
Redirection After
BIOS POST Disabled
Boot Loader
Always
With Disabled Serial Redirection functionality is
disabled at the end of BIOS POST.
If set to Always, all resources and interrupts
associated with Serial Redirection are protected and
not released to DOS. This option lets Serial
Redirection permanently reside at base memory
which allows the DOS console to be redirected. Note,
that graphics output (VGA, SVGA, etc) from DOS
programs is not redirected!
If set to Boot loader, Serial Redirection is active
during the OS boot loader process. This allows boot
status messages to be redirected, but Serial
Redirection will terminate when the OS loads.
Terminal Type ANSI
VT100
VT-UTF8
Select the target terminal type.
Escape sequences representing keystrokes are sent to
the remote terminal based on these settings.
VT-UTF8
Combination Key
Support Disabled
Enabled
This option enables VT-UFT8 combination key
support for ANSI/ VT100 terminals.
Sredir Memory
Display Delay No Delay
Delay 1 Sec
Delay 2 Sec
Delay 4 Sec
Set the delay in seconds to display memory
information if serial redirection is enabled.
Serial Port BIOS
Update Disabled
Enabled
Enable or disable the serial port BIOS update feature.
Disabling saves boot time.