Ampro Corporation COM 830 - Manual (Page 73)

Chapter 4 BIOS Setup Description
COM 830 Reference Manual 67
IDE Detect Time Out
(s) 0, 5, 10, ... 30, 35 Set this option to stop the BIOS from searching for
IDE devices within the specified number of seconds.
Basically, this allows you to fine-tune the settings to
allow for faster boot times. Adjust this setting until a
suitable timing can be found that will allow for all
IDE disk drives that are attached to be detected.
ATA(PI) 80Pin Cable
Detection Host&Device
Host
Device Select the mechanism for detecting 80Pin ATA(PI)
cable.
Note: The use of an 80-conductor ATA cable is
mandatory for running UDMA66 and faster hard disk
drives. The standard 40-conductor ATA cable cannot
handle the higher speeds.