Ampro Corporation COM 830 - Manual (Page 77)

Chapter 4 BIOS Setup Description
COM 830 Reference Manual 71
USB Mass Storage Device Configuration Submenu
Keyboard/Mouse Configuration Submenu
USB Mass Storage
Reset Delay 10 Sec
20 Sec
30 Sec
40 Sec
Number of seconds the legacy USB support BIOS routine
waits for the USB mass storage device after the start unit
command.
USB Mass Storage
Device Configuration sub menu Opens sub menu.
Feature Options Description
Emulation Type Auto
Floppy
Forced FDD
Hard Disk
CD-ROM Every USB MSD that is enumerated by the BIOS will
have an emulation type setup option. This option
specifies the type of emulation the BIOS has to
provide for the device.
Note: The device's formatted type and the emulation
type provided by the BIOS must match for the device
to boot properly.
Select AUTO to let the BIOS auto detect the current
formatted media.
If Floppy is selected then the device will be emulated
as a floppy drive.
Forced FDD allows a hard disk image to be
connected as a floppy image. Works only for drives
formatted with FAT12, FAT16 or FAT32.
Hard Disk allows the device to be emulated as hard
disk.
CDROM assumes the CD-ROM is formatted as
bootable media, specified by the 'El Torito' Format
Specification.
Feature Options Description
Bootup Num-Lock Off
On
Specifies the power-on state of the Num-lock feature
on the numeric keypad of the keyboard.
Typematic Rate Slow
Fast
Specifies the rate at which the computer repeats a key
that is held down.
Slow sets a rate of under 8 times per second.
Fast sets a rate of over 20 times per second.