Canon XEED WUX450 - Manual (Page 168)

Completing Projector Settings
168
Specifying Standby
Power Consumption
> [Network settings] > [Network
standby settings]
Specify network function operating
status in standby mode as follows.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• [Low-power] is the factory default.
• [Low-power] may delay access over the
network for some functions. For faster
access, select [Normal].
• Power consumption when [Network function
(wired)] is [On] varies depending on
whether [Network standby settings] is set to
[Normal] or [Low-power].
Viewing the IP
Address
> [Network settings] > [Detailed settings
(wired)] > [IP address]
View the projector’s IP address as
follows.
Note that the information can only be
displayed, not changed.
To change the settings, access the
DHCP or TCP/IP settings.
Normal All network functions are available
even in standby mode, including
the web screen, control over the
network, and PJLink.
Low-
power All network functions are available
even in standby mode.
However, the projector may be
less responsive than usual when
some functions are initially used.