Checking connection information, Disabling eye-fi transfer, Remove the eye-fi card before – Canon PowerShot ELPH 140 IS User Manual
Page 97
97
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
Disabling Eye-Fi Transfer
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
z
z
Press the <
n> button, choose
[Eye-Fi Settings] on the [
3] tab, and then
press the <
m> button.
z
z
Choose [Eye-Fi trans.], and then choose
[Disable].
•
[Eye-Fi Settings] is not shown unless an Eye-Fi card is in the
camera with its write-protect tab in the unlocked position. For this
reason, you cannot change settings for an inserted Eye-Fi card if
the write-protect tab is in the locked position.
Connection status of Eye-Fi cards in the camera can be checked on the
shooting screen (in regular information display mode) or playback screen (in
simple information display mode).
(Gray)
Not connected
Interrupted
(Blinking white) Connecting
Not communicating
(White)
Connected
Error acquiring Eye-Fi card information*
2
(Animated)
Transfer in progress*
1
*1 Power saving (
) on the camera is temporarily disabled during image transfer.
*2 Restart the camera. Repeated display of this icon may indicate a problem with the
card.
Images labeled with a [
] icon have been transferred.
Checking Connection Information
Check the access point SSID used by the Eye-Fi card or the connection
status, as needed.
z
z
Press the <
n> button, choose
[Eye-Fi Settings] on the [
3] tab, and then
press the <
m> button.
z
z
Choose [Connection info], and then press
the <
m> button.
z
z
The connection information screen is
displayed.